On this Page
Table of Contents | ||||
---|---|---|---|---|
|
Snap type: | Read | |||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|
Description: | This Snap reads the exported file on an Anaplan account.
| |||||||||||
Prerequisites: | [None] | |||||||||||
Support and limitations: | Works in Ultra Task Pipelines. | |||||||||||
Account: | This Snap uses account references created on the Accounts page of SnapLogic Manager to handle access to this endpoint. See Anaplan Account for information on setting up this type of account. | |||||||||||
Views: |
| |||||||||||
Settings | ||||||||||||
Label | Required. The Enter the name for the Snap. You can modify this to be more specific, especially if you have more than one of the same Snap in your pipeline. | |||||||||||
Workspace | Required. The Enter the workspace that contains the target model. Default value: N/A | |||||||||||
Model | Required. The Enter the model on which you want the Snap to operate. Default value: N/A | |||||||||||
Export ID | Required. List Enter the list of the export ID's available in a model. Default value: [None] | |||||||||||
Retry limit | Specifies Specify the maximum number of connection retry attempts in case of a connection failure. If the retry attempts exceed the configured value, the pipeline execution fails and an error message appears. Default value: 3 | |||||||||||
Retry interval | Specifies Specify the minimum retry time interval in seconds. Enter the time interval for the Snap to retry a connection request after a failed connection. The time increases exponentially between failures. For example, if the timeout is set to 3 seconds, the first timeout is at 3, the second is at 4.5 etc. Default value: 3 | |||||||||||
HTTP timeout | Specifies Specify the connection timeout value in seconds. In case of a connection failure, the Snap aborts the pipeline execution. Default value: 60 | |||||||||||
|
|
Examples
This example assumes that you have configured & authorized a valid Anaplan account (see Configuring Anaplan Accounts) to be used with this Snap. The following Anaplan Read Snap reads/exports data from a file existing in your Anaplan Workspace. In this example, data from the file, ActionTest - delete:Test 1.xls, in your Anaplan Workspace, SnapLogic QA, and Model, Anaplan Snap Tests, is read.
After a successful validation of the Snap, you will see a data preview that gives the details of the file that was read/exported:
Insert excerpt | ||||||
---|---|---|---|---|---|---|
|