Versions Compared


  • This line was added.
  • This line was removed.
  • Formatting was changed.

In this Page

Table of Contents
excludeAdditional Resoirces


Pipeline design requires adding and removing Snaps, as well as configuring the various settings in each Snap, before testing to see if the Pipeline validates and executes reliably. This process of trial and error is particularly involving if the Pipelines are long (contain many Snaps) and complex (contain many different types of Snaps with accounts and parameters). SnapLogic Designer provides functionality, easing the process of testing Pipelines-in-development.

SnapLogic introduces this functionality to make Pipeline development easier by allowing you to disable a Snap. Disabling a Snap prevents that Snap and subsequently all downstream Snaps from executing. In SnapLogic Designer, the Execute during Preview checkbox option is replaced with a drop-down menu with the following options:

  • Validate and Execute
  • Execute only
  • Disabled

Although only a limited number of Snaps contained the Execute during Preview checkbox option, the Disabled Snap functionality is available in all Snaps. This functionality enables you to test isolated sections of your Pipeline-in-development by disabling a Snap at the point in the Pipeline where validation/execution testing is not required. When you disable a Snap, only Snaps upstream of the disabled Snap validate and execute. Once executed, these upstream Snaps turn green, while the downstream Snaps turn a light shade of gray. The disabled Snap itself is displayed with a circle and a slash over it.

This functionality simplifies Pipeline development since you can disable certain Snaps temporarily, like Snaps that require access to accounts, whose configuration details you may not have at the moment. You can also test multiple sections of a Pipeline conveniently in the same canvas.   This type of Pipeline execution is available now in available in all Standard-mode Pipelines.   

Support and Limitations

All Snap Packs are supported except the Spark SQL 2.x Snap Pack, all eXtreme Snap Packs, and deprecated Snap Packs, as well as obsolete Snaps, such as Nested Snap).

Best Practices

  • For developing Pipelines, disable any Snap to stop execution of the pipeline at that point. All downstream Snaps are disabled as well.

  • If a Pipeline consists of numerous unconfigured account Snaps, you can disable them or the Snaps that are upstream from them.
  • For Triggered Tasks, Ultra Tasks, and Child Pipelines, the last non-disabled Snap becomes the open output view.
  • For Join Snaps, if one input view of any Snap is downstream from a Disabled Snap, then that Snap is disabled. If you want those downstream Snaps to run, then disconnect the Snap with the disabled input view.
  • You cannot discern whether a non-Disabled Snap without an output view is executing unless you open the Snap settings pop up associated with the Snap. Add an output view to see if such Snaps are being executed.


The following examples display how validation works in a Pipeline where certain Snaps are disabled.

titleDisabling a Snap when a Pipeline has Join Snaps

In this Pipeline with multiple Join Snaps, the Join Snap in the primary branch of the Pipeline is Disabled from executing. 

In this Pipeline, one of the Join Snaps is disabled, stopping validation from all downstream Snaps. However, notice that the MySQL Select Snap is validated because it precedes the branch that has been disabled.

In this Pipeline, the MySQL-Select, which precedes the Join Snap in the Main branch, is disabled, stopping the downstream Snaps from validating.