...
- Log into the Snaplex host machine.
- Navigate to the /
opt/snaplogic/bindirectory. - Depending on your host operating system, use one of the following commands to start the Snaplex:
Linux:./jcc.sh diagnostic
Windows:jcc.bat diagnostic
As the Snaplex starts, the following message appears:Starting Snaplogic Snaplex in diagnostics mode: - In a few minutes, when the report is complete, the following message appears:
A diagnostic report has been generated at:C:\opt\snaplogic\run\log\diagnostic_report.html - Open the report in a web browser to see if there are any issues. For example:
...
See Also
| Filter by label (Content by label) | ||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
...